1. PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
58410B
2.REMOVE DECK BOARD ASSEMBLY
58411A
3.REMOVE NO. 1 DECK BOARD
58412A
4.REMOVE NO. 2 DECK BOARD
64993
5.REMOVE REAR DECK FLOOR BOX
64995
6.REMOVE DECK FLOOR BOX RH
7.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
58810J
8.REMOVE CONSOLE BOX ASSEMBLY
9.REMOVE INTEGRATION CONTROL AND PANEL
55440D
10.REMOVE INSTRUMENT PANEL BOX ASSEMBLY
11.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
84751
12.REMOVE SEAT HEATER SWITCH
Disengage the 2 claws and remove the seat heater switch as shown in the illustration.