Home › Vehicle Interior › SEAT › SEAT HEATER SWITCH › from 2016.05
RM2070E _58 Vehicle Interior _061944 SEAT _0301820 SEAT HEATER SWITCH A

SEAT  SEAT HEATER SWITCH  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

CAUTION:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 7.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 58810J 8.REMOVE CONSOLE BOX ASSEMBLY

Hide 55440D 10.REMOVE INSTRUMENT PANEL BOX ASSEMBLY

Hide 11.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY

Hide 84751 12.REMOVE SEAT HEATER SWITCH

a.
B275002

Disengage the 2 claws and remove the seat heater switch as shown in the illustration.