Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY (for Power Seat) › from 2016.05
RM2070E _58 Vehicle Interior _061944 SEAT _0301824 FRONT SEAT ASSEMBLY(for Power Seat) A

SEAT  FRONT SEAT ASSEMBLY(for Power Seat)  INSTALLATION  


PROCEDURE

Hide 1. PRECAUTION

CAUTION:
·

Be sure to read Precaution thoroughly before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).

·

Wear protective gloves. Sharp areas on the parts may injure your hands.



Hide 2.INSTALL FRONT SEAT ASSEMBLY

a.

Place the front seat assembly in the cabin.

NOTICE:

Be careful not to damage the vehicle body.



b.

Connect each connector under the front seat assembly.


c.

Connect the cable to the negative (-) auxiliary battery terminal.

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



d.

Temporarily install the front seat assembly with the 4 bolts.


e.

Operate the slide and vertical power seat switch knob and move the front seat assembly to the rearmost position.


f.
B229808E05
0.219,2.49 0.375,2.677 0.156,0.188 10 false 1 0.531,2.698 0.719,2.906 0.188,0.208 10 false 2

Tighten the 2 bolts on the front side of the front seat assembly.

Torque:
37 N*m (377 kgf*cm, 27 ft.*lbf)

NOTICE:

Tighten the bolts in the order shown in the illustration.



g.

Operate the slide and vertical power seat switch knob and move the front seat assembly to the foremost position.


h.
B229807E05
2.063,2.677 2.26,2.885 0.198,0.208 10 true 1 1.635,2.26 1.833,2.469 0.198,0.208 10 true 2

Tighten the 2 bolts on the rear side of the front seat assembly.

Torque:
37 N*m (377 kgf*cm, 27 ft.*lbf)

NOTICE:

Tighten the bolts in the order shown in the illustration.



Hide 72138H 3.INSTALL REAR INNER SEAT TRACK BRACKET COVER

a.

Engage the guide.


b.

Engage the claw to install the rear inner seat track bracket cover.


Hide 72138J 4.INSTALL REAR OUTER SEAT TRACK BRACKET COVER

a.

Engage the 2 claws to install the rear outer seat track bracket cover.


Hide 72128A 5.INSTALL FRONT INNER SEAT TRACK BRACKET COVER

a.

Operate the slide and vertical power seat switch knob and move the seat to the rearmost position.


b.

Engage the 2 claws to install the front inner seat track bracket cover.


Hide 72124 6.INSTALL FRONT OUTER SEAT TRACK BRACKET COVER

a.

Engage the 2 claws to install the front outer seat track bracket cover.


Hide 71910A 7.INSTALL FRONT SEAT HEADREST ASSEMBLY

Hide 13.INSPECT FRONT SEAT ASSEMBLY

a.

b.

Check the seat heater operation.

i.

Turn the power switch on.


ii.

Turn the seat heater switch on.


iii.

Wait 5 minutes or more and confirm that the seat surface becomes warm.