1. PRECAUTION
Be sure to read Precaution thoroughly before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).
Wear protective gloves. Sharp areas on the parts may injure your hands.
If the front seat side airbag assembly has deployed, replace the front seat side airbag assembly, separate type front seatback spring assembly, separate type front seatback cover and separate type front seatback pad with the necessary parts in accordance with the extent of the collision damage.
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
58410B
2.REMOVE DECK BOARD ASSEMBLY
58411A
3.REMOVE NO. 1 DECK BOARD
58412A
4.REMOVE NO. 2 DECK BOARD
64993
5.REMOVE REAR DECK FLOOR BOX
64995
6.REMOVE DECK FLOOR BOX RH
71910A
7.REMOVE FRONT SEAT HEADREST ASSEMBLY
72128A
8.REMOVE FRONT INNER SEAT TRACK BRACKET COVER
Operate the slide and vertical power seat switch knob and move the front seat assembly to the rearmost position.
Disengage the 2 claws to remove the front inner seat track bracket cover.
72124
9.REMOVE FRONT OUTER SEAT TRACK BRACKET COVER
Disengage the 2 claws to remove the front outer seat track bracket cover.
72138H
10.REMOVE REAR INNER SEAT TRACK BRACKET COVER
Operate the slide and vertical power seat switch knob and move the front seat assembly to the foremost position.
Disengage the claw.
Disengage the guide to remove the rear inner seat track bracket cover.
72138J
11.REMOVE REAR OUTER SEAT TRACK BRACKET COVER
Disengage the 2 claws to remove the rear outer seat track bracket cover.
12.REMOVE FRONT SEAT ASSEMBLY
Remove the 2 bolts on the rear side of the front seat assembly.
Operate the slide and vertical power seat switch knob and move the front seat assembly to the rearmost position.
Remove the 2 bolts on the front side of the front seat assembly.
Operate the reclining power seat switch knob and move the seatback to the upright position.
Operate the slide and vertical power seat switch knob and move the front seat assembly to the center position.
Disconnect the cable from the negative (-) auxiliary battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative auxiliary (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
Disconnect each connector under the front seat assembly.
Remove the front seat assembly.
Be careful not to damage the vehicle body.