The A/C inverter assembly monitors the voltage of the auxiliary battery. It stops compressor control and stores this DTC when the monitored voltage is outside the specified range.
The output DTC is memorized as a history DTC. Compressor control may not resume unless the power switch is turned off.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B1471/71 | ·
Open or short in A/C inverter high voltage power resource system ·
The boost inverter is broken or malfunctioning. |
·
Electric vehicle fuse ·
No. 2 engine wire (harness or connector between compressor with motor assembly and inverter with converter assembly) ·
Compressor with motor assembly ·
Hybrid control system ·
CAN communication system |
Wear insulated gloves and pull out the service plug grip before inspection as procedures may require disconnecting high-voltage connectors. Carry the removed service plug in your pocket to prevent other technicians from accidentally reconnecting it while you are servicing the vehicle.
Do not touch the high-voltage connectors or terminals for 10 minutes after the service plug grip is removed.
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
The hybrid control system and air conditioning system output DTCs separately. Inspect DTCs following the flow chart for the hybrid control system first if any DTCs from those systems are output simultaneously.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Use the GTS to check if the CAN communication system is functioning normally.
| Result | Proceed to |
|---|---|
| CAN DTC is not output | A |
| CAN DTC is output | B |
A
B
Check if DTCs for the hybrid control system are output using the GTS.
Hybrid control system DTCs are not output.
OK
NG
Be sure to wear insulated gloves.
Turn the power switch off.
Remove the service plug grip (See page Engine / Hybrid System>HYBRID / BATTERY CONTROL>SERVICE PLUG GRIP>REMOVAL).
Do not touch the high-voltage connectors or terminals for 10 minutes after the service plug grip is removed.
After removing the service plug grip, turning the power switch on (READY) may cause a malfunction. Do not turn the power switch on (READY) with the service plug grip removed.
Remove the inverter terminal cover (See page Engine / Hybrid System>HYBRID / BATTERY CONTROL>INVERTER WITH CONVERTER>REMOVAL).
Be sure to prevent foreign objects or water from entering the inverter with converter assembly.
Check that bolts A and B are tightened securely.
Measure the resistance according to the value(s) in the table below.
| Tester Item
(Tester Connection) |
Condition | Specified Condition |
|---|---|---|
| Electric vehicle fuse
(A - B) |
Always | Below 1 Ω |
| *a | Inverter with Converter Assembly |
| *b | Electric Vehicle Fuse |
OK
NG
Be sure to wear insulated gloves.
Disconnect the No. 2 engine wire connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| E1-1 (PE) - E3-2 (ACPE) | Always | Below 1 Ω |
| E1-2 (PB) - E3-1 (ACPB) | Always | Below 1 Ω |
| E1-1 (PE) - Body ground | Always | 10 kΩ or higher |
| E1-2 (PB) - Body ground | Always | 10 kΩ or higher |
OK
NG