The compressor with motor assembly monitors the control power voltage in the circuit. It stops the compressor circuit and stores this DTC when the monitored voltage is outside the specified range.
The output DTC is memorized as a history DTC. Compressor control may not resume unless the power switch is turned off.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B1477/77 | An open or short to ground in the inverter control power voltage circuit. | ·
Compressor with motor assembly ·
CAN communication system |
Wear insulated gloves and pull out the service plug grip before inspection as procedures may require disconnecting high-voltage connectors. Carry the removed service plug in your pocket to prevent other technicians from accidentally reconnecting it while you are servicing the vehicle.
Do not touch the high-voltage connectors or terminals for 10 minutes after the service plug grip is removed.
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
The hybrid control system and air conditioning system output DTCs separately. Inspect DTCs following the diagnosis procedure for the hybrid control system first if any DTCs from those systems are output simultaneously.
Use the GTS to check if the CAN communication system is functioning normally.
| Result | Proceed to |
|---|---|
| CAN DTC is not output | A |
| CAN DTC is output | B |
A
B