Home › Vehicle Interior › INTERIOR PANELS / TRIM › ROOF SUNSHADE › 2012.03–2014.11
RM2070E _58 Vehicle Interior _061948 INTERIOR PANELS / TRIM _0301861 ROOF SUNSHADE A

INTERIOR PANELS / TRIM  ROOF SUNSHADE  INSTALLATION  


PROCEDURE

Hide 63250H 1.INSTALL SUNSHADE HOUSING ASSEMBLY

a.

Install the sunshade housing assembly with the 11 nuts.

Torque:
5.8 N*m (59 kgf*cm, 51 in.*lbf)

NOTICE:

Do not damage the sunshade housing assembly or body interior.



b.

Connect the connector.


Hide 63103A 2.INSTALL ROOF PANEL REINFORCEMENT SUB-ASSEMBLY

a.

Install the roof panel reinforcement sub-assembly with the 2 bolts.

Torque:
11 N*m (112 kgf*cm, 8 ft.*lbf)


Hide 61247F 3.INSTALL INNER ROOF SIDE RAIL REINFORCEMENT

a.

Engage the 2 guides.


b.

Install the inner roof side rail reinforcement with the 3 bolts.

HINT:

Use the same procedure for the other reinforcement.



Hide 63306 4.INSPECT SUNSHADE TRIM SUB-ASSEMBLY

a.

Install the roof headlining assembly. (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION)


b.

Connect the roof headlining assembly. (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION)


c.

Check the operation of the roof sunshade assembly.

i.

Connect the connector to the map light assembly.


ii.

Turn the power switch to on (IG).


iii.

Operate the roof sunshade switch and check that no unusual noises can be heard when the roof sunshade is operated in both directions.


iv.

Turn the power switch to off.


v.

Disconnect the connector from the map light assembly.



Hide 5.INSTALL ROOF HEADLINING ASSEMBLY

Hide 7. INITIALIZE ROOF SUNSHADE ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY)