63250H
1.INSTALL SUNSHADE HOUSING ASSEMBLY
Install the sunshade housing assembly with the 11 nuts.
Do not damage the sunshade housing assembly or body interior.
Connect the connector.
63103A
2.INSTALL ROOF PANEL REINFORCEMENT SUB-ASSEMBLY
Install the roof panel reinforcement sub-assembly with the 2 bolts.
61247F
3.INSTALL INNER ROOF SIDE RAIL REINFORCEMENT
Engage the 2 guides.
Install the inner roof side rail reinforcement with the 3 bolts.
Use the same procedure for the other reinforcement.
63306
4.INSPECT SUNSHADE TRIM SUB-ASSEMBLY
Install the roof headlining assembly. (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION)
Connect the roof headlining assembly. (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION)
Check the operation of the roof sunshade assembly.
Connect the connector to the map light assembly.
Turn the power switch to on (IG).
Operate the roof sunshade switch and check that no unusual noises can be heard when the roof sunshade is operated in both directions.
Turn the power switch to off.
Disconnect the connector from the map light assembly.
5.INSTALL ROOF HEADLINING ASSEMBLY
6. CHECK ROOF SUNSHADE ASSEMBLY
7. INITIALIZE ROOF SUNSHADE ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY)