If a door glass or a power window regulator motor assembly does not operate smoothly, the jam protection function may be triggered automatically, resulting in the auto up function being unable to fully close the window.
This symptom may occur for any of the windows.
If a power window regulator motor assembly has been replaced with a new one, initialize the power window control system (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION).
If a power window regulator motor assembly and door window regulator sub-assembly have been removed and installed, or if a power window regulator motor assembly was reused when a door glass or door glass run was replaced, initialize the power window control system (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION).
Initialize the power window regulator motor assembly (applicable location) (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION).
NEXT
Check that all power windows move when the auto up and down functions of the multiplex network master switch assembly, power window regulator switch assembly and rear power window regulator switch assembly (for LH, RH doors) are operated (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>OPERATION CHECK).
Auto up and down functions are normal (applicable location).
OK
NG
Remove the window regulator.
Install the window glass onto the door glass run.
Check if the door window regulator operates smoothly.
Check that the window glass slides smoothly when sliding it up by hand.
Door window glass slides smoothly.
| Result | Proceed to |
|---|---|
| NG | A |
| OK (Driver door power window) | B |
| OK (Front passenger door power window) | B |
| OK (Rear LH door power window) | C |
| OK (Rear RH door power window) | C |
Ensure the following:
The window glass fits with the glass run without improper contact or deformation.
Foreign objects are not caught in the glass run.
Perform initialization again.
A
B
C