Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
1. PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
58410B
2.REMOVE DECK BOARD ASSEMBLY
58411A
3.REMOVE NO. 1 DECK BOARD
58412A
4.REMOVE NO. 2 DECK BOARD
64993
5.REMOVE REAR DECK FLOOR BOX
64995
6.REMOVE DECK FLOOR BOX RH
7.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
69284D
8.REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG
9.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL
74262
10.REMOVE REAR DOOR ARMREST COVER
67604
11.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY
86160Y
12.REMOVE REAR NO. 2 SPEAKER ASSEMBLY (for 8 Speakers)
67628
13.REMOVE REAR DOOR TRIM BRACKET
67842E
14.REMOVE REAR DOOR SERVICE HOLE COVER
68152C
15.REMOVE REAR DOOR GLASS RUN
67872
16.DISCONNECT REAR DOOR WEATHERSTRIP
Disconnect the upper part of rear door weatherstrip.
67408D
17.REMOVE REAR DOOR WINDOW GUIDE SUB-ASSEMBLY
67488C
18.REMOVE REAR DOOR REAR GUIDE SEAL
68104
19.REMOVE REAR DOOR GLASS SUB-ASSEMBLY
20.REMOVE REAR DOOR POWER WINDOW REGULATOR ASSEMBLY
85720E
21.REMOVE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY
Using a T25 "TORX" socket wrench, remove the 3 screws and the rear power window regulator motor assembly.