Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM › 2013.08–2014.11
RM2070E _59 Vehicle Exterior _061949 WINDOW / GLASS _0301864 POWER WINDOW CONTROL SYSTEM C

WINDOW / GLASS  POWER WINDOW CONTROL SYSTEM  B2313  Glass Position Initialization Incomplete  


DESCRIPTION

The power window regulator motor assembly is operated by the multiplex network master switch or power window regulator switch assembly. The power window regulator motor assembly has motor, regulator and ECU functions.

When the ECU determines that the power window regulator motor assembly has not been initialized, DTC B2313 is stored.

D-Door Motor
DTC No. DTC Detection Condition Trouble Area
B2313
·

Power window regulator motor assembly not initialized

·

Power window regulator motor assembly malfunctions

·

Auxiliary battery disconnected when power switch on (IG)


·

Power window regulator motor assembly (for driver door) not initialized

·

Power window regulator motor assembly (for driver door)



P-Door Motor
DTC No. DTC Detection Condition Trouble Area
B2313
·

Power window regulator motor assembly not initialized

·

Power window regulator motor assembly malfunctions

·

Auxiliary battery disconnected when power switch on (IG)


·

Power window regulator motor assembly (for front passenger door) not initialized

·

Power window regulator motor assembly (for front passenger door)



RL-Door Motor
DTC No. DTC Detection Condition Trouble Area
B2313
·

Power window regulator motor assembly not initialized

·

Power window regulator motor assembly malfunctions

·

Auxiliary battery disconnected when power switch on (IG)


·

Power window regulator motor assembly (for rear LH door) not initialized

·

Power window regulator motor assembly (for rear LH door)



RR-Door Motor
DTC No. DTC Detection Condition Trouble Area
B2313
·

Power window regulator motor assembly not initialized

·

Power window regulator motor assembly malfunctions

·

Auxiliary battery disconnected when power switch on (IG)


·

Power window regulator motor assembly (for rear RH door) not initialized

·

Power window regulator motor assembly (for rear RH door)



CAUTION / NOTICE / HINT

NOTICE:
·

DTC B2313 can be stored in each power window regulator motor assembly (power window ECU).

·

When disconnecting the auxiliary battery while the power switch on (IG), DTC B2313 is stored.

·

If a power window regulator motor assembly has been replaced with a new one, initialize the power window control system (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION).



PROCEDURE

1.PERFORM INITIALIZATION (APPLICABLE LOCATION)
a.

Turn the power switch on (IG).


b.

Initialize the power window regulator motor assembly (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION).

HINT:

Initialize the power window regulator motor assembly that has DTC B2313 stored in its ECU.




NEXT

2.CHECK DTC OUTPUT
2.CHECK DTC OUTPUT
a.

Turn the power switch off.


b.

Wait for at least 10 seconds, and then turn the power switch on (IG).


c.

Check for DTCs (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>DTC CHECK / CLEAR).

HINT:

Check for DTCs for the power window regulator motor assembly that has DTC B2313 stored in its ECU.


OK:

DTC B2313 is not output.


Result:
Result Proceed to
OK A
NG (Driver door power window) B
NG (Front passenger door power window) B
NG (Rear LH door power window) C
NG (Rear RH door power window) C




A

END (POWER WINDOW CONTROL SYSTEM HAS NOT BEEN INITIALIZED)

B

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Driver Door or Front Passenger Door)

C

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Rear LH Door or Rear RH Door)