Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM › 2013.08–2014.11
RM2070E _59 Vehicle Exterior _061949 WINDOW / GLASS _0301864 POWER WINDOW CONTROL SYSTEM J

WINDOW / GLASS  POWER WINDOW CONTROL SYSTEM  Rear Power Window LH does not Operate with Rear Power Window Switch LH  


DESCRIPTION

When the hybrid control system is running or the power switch is on (IG), the power window regulator motor assembly (for rear LH door) is operated by the rear power window regulator switch assembly (for LH door). The power window regulator motor has motor, regulator, and ECU functions.

WIRING DIAGRAM

B203373E97
1.635,0.661 3.597,0.986 1.962,0.325 10 from Main Body ECU (Multiplex Network Body ECU) 1.201,4.351 2.857,4.514 1.656,0.162 10 : LIN Communication Line 0.115,3.529 0.332,3.672 0.216,0.143 10 Q2 5.032,3.681 7.034,3.997 2.002,0.317 10 Power Window Regulator Motor Assembly (for Rear LH Door) 0.117,3.681 2.071,3.993 1.955,0.312 10 Rear Power Window Regulator Switch Assembly (for LH Door) 5.032,3.517 5.255,3.667 0.224,0.150 10 Q4 5.474,0.587 5.603,0.753 0.129,0.167 10 9 5.42,1.72 5.605,1.887 0.185,0.167 10 10 1.611,1.72 1.739,1.887 0.128,0.167 10 6 1.611,2.254 1.718,2.420 0.108,0.167 10 7 5.474,2.255 5.603,2.422 0.129,0.167 10 7 5.698,0.712 6.032,0.882 0.334,0.170 10 LIN 5.698,1.817 5.914,1.958 0.216,0.141 10 UP 5.698,2.365 6.158,2.507 0.460,0.142 10 DOWN 1.286,1.809 1.497,1.954 0.211,0.145 10 UP 1.037,2.367 1.495,2.511 0.458,0.144 10 DOWN 1.611,2.82 1.739,2.987 0.128,0.167 10 1 1.166,2.935 1.496,3.075 0.330,0.140 10 GND

CAUTION / NOTICE / HINT

NOTICE:
·

The power window control system uses a LIN communication system. Inspect the communication function by following How to Proceed with Troubleshooting (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING). Troubleshoot the power window control system after confirming that the communication system is functioning properly.

·

If the power window regulator motor assembly (for rear LH door) has been replaced with a new one, initialize the power window control system (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION).



PROCEDURE

1.READ VALUE USING GTS (Main Body)
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Main Body / Data List.


e.

Read the Data List according to the display on the GTS.

Main Body
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Communication RL-Door Motor Connection status between power window regulator motor (for rear LH door) and main body ECU (multiplex network body ECU) / STOP or OK STOP: Communication stopped
OK: Normal communication
-

OK:

On the GTS screen, OK is displayed.




OK

2.READ VALUE USING GTS (RL-Door Motor)

NG

GO TO LIN COMMUNICATION SYSTEM (Proceed to How to Proceed with Troubleshooting)

2.READ VALUE USING GTS (RL-Door Motor)
a.

Enter the following menus: Body Electrical / RL-Door Motor / Data List.


b.

Read the Data List according to the display on the GTS.

RL-Door Motor
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
RL Door P/W Up SW Rear LH door power window manual up switch signal / OFF or ON OFF: Rear LH door power window manual up switch not operated
ON: Rear LH door power window manual up switch operated
-
RL Door P/W Down SW Rear LH door power window manual down switch signal / OFF or ON OFF: Rear LH door power window manual down switch not operated
ON: Rear LH door power window manual down switch operated
-

OK:

On the GTS screen, ON or OFF is displayed accordingly.




OK

3.PERFORM ACTIVE TEST USING GTS (RL-Door Motor)

NG

4.INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY (for LH Door)
3.PERFORM ACTIVE TEST USING GTS (RL-Door Motor)
a.

Enter the following menus: Body Electrical / RL-Door Motor / Active Test.


b.

Perform the Active Test according to the display on the GTS.

CAUTION:

Be careful to avoid injuries as this test causes vehicle parts to move. During the Active Test, the jam protection function will not operate.


RL-Door Motor
Tester Display Test Part Control Range Diagnostic Note
Power Window Power window OFF / UP / DOWN -

OK:

Rear LH power window operates normally.




OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

NG

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Rear LH Door)

4.INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY (for LH Door)
a.
B203473E30
0.623,1.607 0.776,1.750 0.153,0.144 10 *a 1.716,2.439 2.047,2.581 0.331,0.142 10 GND 0.227,3.045 0.694,3.191 0.467,0.146 10 DOWN 1.445,3.045 1.658,3.186 0.213,0.141 10 UP 1.699,2.515 1.413,2.515 false 1.201,2.785 1.201,3.128 1.201,3.128 1.416,3.128 false 1.004,2.785 1.004,3.128 1.004,3.128 0.789,3.128 false

Remove the rear power window regulator switch assembly (for LH door) (See page Vehicle Exterior>WINDOW / GLASS>REAR POWER WINDOW SWITCH>REMOVAL).


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
6 (UP) - 1 (GND) Auto up or up position Below 1 Ω
7 (DOWN) - 1 (GND) Auto down or down position Below 1 Ω


Text in Illustration
*a Component without harness connected
(Rear Power Window Regulator Switch Assembly (for LH Door))



OK

5.CHECK HARNESS AND CONNECTOR (REAR LH DOOR SWITCH - REAR LH DOOR MOTOR AND BODY GROUND)

NG

REPLACE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY (for LH Door)

5.CHECK HARNESS AND CONNECTOR (REAR LH DOOR SWITCH - REAR LH DOOR MOTOR AND BODY GROUND)
a.

Disconnect the Q4 power window regulator motor assembly (for rear LH door) connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
Q2-6 (UP) - Q4-10 (UP) Always Below 1 Ω
Q2-7 (DOWN) - Q4-7 (DOWN) Always Below 1 Ω
Q2-1 (GND) - Body ground Always Below 1 Ω
Q2-6 (UP) - Body ground Always 10 kΩ or higher
Q2-7 (DOWN) - Body ground Always 10 kΩ or higher
Q4-10 (UP) - Body ground Always 10 kΩ or higher
Q4-7 (DOWN) - Body ground Always 10 kΩ or higher




OK

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Rear LH Door)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR