Use the same procedure for both the RH and LH sides.
The procedure described below is for the LH side.
87961
1.REMOVE OUTER MIRROR
87945
2.REMOVE OUTER MIRROR COVER
81740
3.REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY
87966
4.REMOVE OUTER MIRROR RETRACTOR
Cut the wire harness at the position shown in the illustration.
| *a | Cut |
Make sure to replace the wire harness with a new one.
Remove the vinyl tape.
Remove the gasket.
Make sure to replace the gasket with a new one.
Disengage the 3 claws as shown in the illustration.
Disengage the 2 claws and 3 guides and remove the lower cover.
Make sure to replace the lower cover with a new one.
Disengage the clamp.
Using a T25 "TORX" socket wrench, remove the 3 screws and base.
Make sure to replace the "TORX" screws with new ones.
Remove the 3 screws.
Disengage the clamp.
Disconnect the 2 connectors and remove the mirror actuator.
Remove the 2 screws.
Disengage the guide and remove the frame sub-assembly as shown in the illustration.
Make sure to replace the frame sub-assembly wire harness with a new one.