This circuit detects the state of the windshield wiper switch assembly (front wiper switch and front washer switch) and sends it to the windshield wiper relay assembly.
Remove the windshield wiper switch assembly (See page Vehicle Exterior>WIPER / WASHER>WIPER SWITCH>REMOVAL).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| L48-3 (+1) - L48-1 (+S) | OFF | Below 1 Ω |
| AUTO | ||
| L48-3 (+1) - L48-2 (+B) | MIST | |
| LO | ||
| L48-2 (+B) - L48-4 (+2) | HI | |
| L48-9 (AUTO) - L48-10 (E) | AUTO |
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| L49-2 (EW) - L49-3 (WF) | ON | Below 1 Ω |
| OFF | 10 kΩ or higher |
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| L48-7 (VR1) - L48-8 (VR2) | P1 | 209 to 231 Ω |
| P2 | 114 to 126 Ω | |
| P3 | 58.9 to 65.1 Ω | |
| P4 | Below 1 Ω |
*: The rain sensor sensitivity can be adjusted by the windshield wiper switch adjusting ring.
| *1 | Windshield Wiper Switch Assembly (Adjusting Ring Position) |
| *a | Component without harness connected
(Windshield Wiper Switch Assembly) |
OK
NG
Disconnect the L146 windshield wiper relay assembly connector and A35 windshield wiper motor assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L48-2 (+B) - L146-2 (IG) | Always | Below 1 Ω |
| L48-2 (+B) - Body ground | Always | 10 kΩ or higher |
| L48-3 (+1) - A35-1 (+1)*1 | Always | Below 1 Ω |
| L48-3 (+1) - A35-3 (+1)*2 | Always | Below 1 Ω |
| L48-3 (+1) - Body ground | Always | 10 kΩ or higher |
| L48-4 (+2) - L146-11 (+2) | Always | Below 1 Ω |
| L48-4 (+2) - A35-4 (+2)*1 | Always | Below 1 Ω |
| L48-4 (+2) - A35-5 (+2)*2 | Always | Below 1 Ω |
| L48-4 (+2) - Body ground | Always | 10 kΩ or higher |
| L48-1 (+S) - L146-10 (+1) | Always | Below 1 Ω |
| L48-1 (+S) - Body ground | Always | 10 kΩ or higher |
| L48-9 (AUTO) - L146-3 (C1) | Always | Below 1 Ω |
| L48-9 (AUTO) - Body ground | Always | 10 kΩ or higher |
| L48-10 (E) - L146-5 (CO) | Always | Below 1 Ω |
| L48-10 (E) - Body ground | Always | 10 kΩ or higher |
| L48-7 (VR1) - L146-21 (VR1) | Always | Below 1 Ω |
| L48-7 (VR1) - Body ground | Always | 10 kΩ or higher |
| L48-8 (VR2) - L146-8 (VR2) | Always | Below 1 Ω |
| L48-8 (VR2) - Body ground | Always | 10 kΩ or higher |
| L49-3 (WF) - L146-25 (W) | Always | Below 1 Ω |
| L49-3 (WF) - Body ground | Always | 10 kΩ or higher |
| L49-2 (EW) - Body ground | Always | Below 1 Ω |
*1: for LHD
*2: for RHD
OK
NG