Home › Vehicle Exterior › WIPER / WASHER › WIPER AND WASHER SYSTEM › 2012.03–2014.11
RM2070E _59 Vehicle Exterior _061952 WIPER / WASHER _0301891 WIPER AND WASHER SYSTEM J

WIPER / WASHER  WIPER AND WASHER SYSTEM  Headlight Signal Circuit  


DESCRIPTION

The headlight cleaner control relay detects the low beam headlights status.

WIRING DIAGRAM

E250817E01
5.42,1.256 5.828,1.407 0.408,0.151 10 HDLO 5.241,1.172 5.338,1.323 0.097,0.151 10 1 2.655,1.256 2.855,1.407 0.199,0.151 10 2C 2.668,1.071 2.843,1.222 0.175,0.151 10 35 1.822,1.256 2.049,1.407 0.227,0.151 10 MB 1.259,1.256 1.663,1.407 0.404,0.151 10 HDLO 1.848,1.071 2.023,1.222 0.175,0.151 10 25 4.834,2.13 5.099,2.280 0.265,0.151 10 A44 4.834,2.298 6.844,2.449 2.010,0.151 10 Headlight Cleaner Control Relay 1.748,1.91 3.372,2.244 1.625,0.335 10 Instrument Panel Junction Block Assembly 0.483,2.709 2.122,3.044 1.639,0.335 10 Main Body ECU (Multiplex Network Body ECU)

CAUTION / NOTICE / HINT

NOTICE:

First check that the low beam headlights operate normally.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY - HEADLIGHT CLEANER CONTROL RELAY)
a.

Disconnect the A44 headlight cleaner control relay connector.


b.

Disconnect the 2C instrument panel junction block assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A44-1 (HDLO) - 2C-35 Always Below 1 Ω
A44-1 (HDLO) - Body ground Always 10 kΩ or higher




OK

2.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY
a.
U191239E01
0.164,0.16 0.364,0.347 0.200,0.187 10 *a 1.62,0.824 1.858,1.005 0.238,0.181 10 2C 1.614,2.99 1.964,3.171 0.350,0.181 10 MB 2.347,3.762 2.760,3.913 0.413,0.151 10 HDLO 2.565,3.486 2.565,3.748 false

Remove the instrument panel junction block assembly (See page Power Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL).


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
2C-35 - MB-25 (HDLO) Always Below 1 Ω


Text in Illustration
*a Component without harness connected
(Instrument Panel Junction Block Assembly)



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY