The windshield wiper relay assembly receives a signal from the rain sensor to control the auto wiper system.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Disconnect the L146 windshield wiper relay assembly connector.
Disconnect the U12 rain sensor connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L146-14 (MPX1) - U12-1 (MPX) | Always | Below 1 Ω |
| U12-1 (MPX) - Body ground | Always | 10 kΩ or higher |
OK
NG
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| U12-4 (SIG) - U12-2 (ES) | Power switch on (IG) | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| U12-2 (ES) - Body ground | Always | Below 1 Ω |
OK
NG
Reconnect the U12 rain sensor connector.
Connect an oscilloscope to the rain sensor connector.
Check for pulses.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| U12-1 (MPX) - U12-2 (ES) | Power switch on (IG) | Pulse generation |
| *a | Component with harness connected
(Rain Sensor) |
OK
NG