Home › Vehicle Exterior › WIPER / WASHER › WASHER MOTOR(for Front Side) › 2012.03–2014.11
RM2070E _59 Vehicle Exterior _061952 WIPER / WASHER _0301897 WASHER MOTOR(for Front Side) A

WIPER / WASHER  WASHER MOTOR(for Front Side)  REMOVAL  


PROCEDURE

Hide 1.REMOVE FRONT WHEEL RH

Hide 75850A 2.REMOVE BODY ROCKER PANEL MOULDING ASSEMBLY RH

HINT:

Use the same procedure as for the LH side (See page Vehicle Exterior>EXTERIOR PANELS / TRIM>ROCKER PANEL MOULDING>REMOVAL).


Hide 53875A 3.REMOVE FRONT FENDER LINER RH

a.
E223646E02
0.401,2.443 0.577,2.598 0.176,0.154 10 *a

Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

Text in Illustration
*a 90°


b.
E223648E03
0.796,2.411 0.796,2.763 0.796,2.763 1.524,2.763 false 1.207,1.999 1.207,2.763 false 1.542,2.672 1.707,2.827 0.165,0.155 10 *1

Remove the 9 clips and 3 screws.


c.

Using a clip remover, remove the 2 grommets and front fender liner RH.

Text in Illustration
*1 Grommet

HINT:

The grommet needs to be replaced with a new one because it will break when it is removed.



Hide 4.DRAIN WASHER FLUID

a.
E224718

Disconnect the washer hose from the windshield washer motor and pump assembly, and drain the washer fluid.

HINT:

Use a container to collect the washer fluid.



Hide 85310 5.REMOVE WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY

a.
E224719

Disconnect the connector.


b.

Remove the windshield washer motor and pump assembly.