1.REMOVE FRONT BUMPER ASSEMBLY
17750A
2.REMOVE INLET AIR CLEANER ASSEMBLY
85942
3.REMOVE HEADLIGHT CLEANER CONTROL RELAY
Disengage the clip and separate the washer jar cap of the washer jar assembly.
| *1 | Washer Jar Cap of the Washer Jar Assembly |
Disconnect the 2 connectors.
Disengage the clamp.
Remove the 2 bolts.
Disengage the hose clamp.
Disconnect the 2 washer hoses, and drain the washer fluid.
Use a container to collect the washer fluid.
Disconnect the 2 connectors.
Disengage the clamp.
Remove the bolt and washer jar assembly.
Disengage the claw and remove the headlight cleaner control relay as shown in the illustration.