The main body ECU (multiplex network body ECU) controls the rear fog light relay.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Main Body / Active Test.
Check that the relay operates.
| Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| Rear Fog Light Relay | Rear fog light relay | ON/OFF | Light control switch is in head position |
Rear fog light relay operates. (Rear fog light comes on.)
OK
NG
Remove the rear fog light relay.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 - 5 | Voltage is not applied between terminals 1 and 2 | 10 kΩ or higher |
| 3 - 5 | Voltage is applied between terminals 1 and 2 | Below 1 Ω |
OK
NG
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L153-2 - Body ground | Light control switch off → tail | Below 1 V → 11 to 14 V |
| L153-5 - Body ground | Always | 11 to 14 V |
OK
NG
Disconnect the R17 rear combination light assembly LH connector or the S18 rear combination light assembly RH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L153-3 - R17-1 | Always | Below 1 Ω |
| L153-3 - S18-1 | Always | Below 1 Ω |
| L153-3 - Body ground | Always | 10 kΩ or higher |
OK
NG
Disconnect the 2B instrument panel junction block assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L153-1 - 2B-26 | Always | Below 1 Ω |
| 2B-26 - Body ground | Always | 10 kΩ or higher |
OK
NG
Remove the instrument panel junction block assembly (See page Power Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2B-26 - MB-27 (RFGO) | Always | Below 1 Ω |
| 2B-26 - Body ground | Always | 10 kΩ or higher |
| *a | Component without harness connected
(Instrument Panel Junction Block Assembly) |
OK
NG