The main body ECU (multiplex network body ECU) controls the operation of the TAIL relay.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Main Body / Active Test.
Check that the relay operates.
| Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| Taillight Relay | Taillight relay | ON/OFF | - |
Taillight relay operates. (Taillights illuminate.)
OK
NG
Remove the instrument panel junction block assembly (See page Power Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL).
| *A | for LHD | *B | for RHD |
| *a | Component without harness connected
(Instrument Panel Junction Block Assembly) |
- | - |
Connect a positive (+) lead from the auxiliary battery to terminal 2E-1*1 or 2F-1*2.
Connect a negative (-) lead from the auxiliary battery to terminal MB-14.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2C-10 - Auxiliary battery negative terminal | Always | 11 to 14 V |
| 2D-18 - Auxiliary battery negative terminal | Always | 11 to 14 V |
| 2B-7 - Auxiliary battery negative terminal | Always | 11 to 14 V |
*1: for LHD
*2: for RHD
OK
NG
Disconnect the 2E*1 or 2F*2 instrument panel junction block assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2E-1*1 - Body ground | Power switch off | 11 to 14 V |
| 2F-1*2 - Body ground | Power switch off | 11 to 14 V |
*1: for LHD
*2: for RHD
OK
NG