84340
1.INSTALL STOP LIGHT SWITCH ASSEMBLY
Insert the stop light switch assembly until the threaded sleeve hits the pedal.
When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.
Make a quarter turn clockwise to install the stop light switch assembly.
or less
When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.
Connect the connector.
Check the protrusion of the plunger.
| Area | Measurement |
|---|---|
| a | 0.5 to 2.6 mm (0.0197 to 0.102 in.) |
If the protrusion is not as specified, recheck switch installation and inspect brake pedal adjustment if necessary (See page Brake>BRAKE SYSTEM (OTHER)>BRAKE PEDAL (for LHD)>ADJUSTMENT).
Do not depress or support the brake pedal.
55606
2.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY