Home › Vehicle Exterior › LIGHTING (EXT) › STOP LIGHT SWITCH › from 2014.11
RM2070E _59 Vehicle Exterior _061953 LIGHTING (EXT) _0301917 STOP LIGHT SWITCH A

LIGHTING (EXT)  STOP LIGHT SWITCH  INSTALLATION  


PROCEDURE

Hide 84340 1.INSTALL STOP LIGHT SWITCH ASSEMBLY

a.
E167768

Insert the stop light switch assembly until the threaded sleeve hits the pedal.

NOTICE:

When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.



b.
E167769E05
1.552,1.948 1.854,2.177 0.302,0.229 10 a

Make a quarter turn clockwise to install the stop light switch assembly.

Torque:
1.5 N*m (15 kgf*cm, 13 in.*lbf)

or less


NOTICE:

When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.



c.

Connect the connector.


d.

Check the protrusion of the plunger.

Protrusion of the plunger
Area Measurement
a 0.5 to 2.6 mm (0.0197 to 0.102 in.)

If the protrusion is not as specified, recheck switch installation and inspect brake pedal adjustment if necessary (See page Brake>BRAKE SYSTEM (OTHER)>BRAKE PEDAL (for LHD)>ADJUSTMENT for LHD or Brake>BRAKE SYSTEM (OTHER)>BRAKE PEDAL (for RHD)>ADJUSTMENT for RHD).

NOTICE:

Do not depress or support the brake pedal.



Hide 55606 2.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY