Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR DOOR BELT MOULDING › 2014.11–2016.05
RM2070E _59 Vehicle Exterior _061955 EXTERIOR PANELS / TRIM _0301935 REAR DOOR BELT MOULDING A

EXTERIOR PANELS / TRIM  REAR DOOR BELT MOULDING  INSTALLATION  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 75740 2.INSTALL REAR DOOR BELT MOULDING ASSEMBLY

a.
B275152

Engage the 8 claws to install the rear door belt moulding assembly.


Hide 68104 3.INSTALL REAR DOOR GLASS SUB-ASSEMBLY

Hide 67488C 4.INSTALL REAR DOOR REAR GUIDE SEAL

Hide 67408D 5.INSTALL REAR DOOR WINDOW GUIDE SUB-ASSEMBLY

Hide 68152C 6.INSTALL REAR DOOR GLASS RUN

Hide 67842E 7.INSTALL REAR DOOR SERVICE HOLE COVER

Hide 67628 8.INSTALL REAR DOOR TRIM BRACKET

Hide 67604 9.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

Hide 74262 10.INSTALL REAR DOOR ARMREST COVER

Hide 11.INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

Hide 69284D 12.INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG

Hide 13.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 19.INITIALIZE POWER WINDOW CONTROL SYSTEM