Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR DOOR WINDOW FRAME MOULDING › from 2016.05
RM2070E _59 Vehicle Exterior _061955 EXTERIOR PANELS / TRIM _0301938 REAR DOOR WINDOW FRAME MOULDING A

EXTERIOR PANELS / TRIM  REAR DOOR WINDOW FRAME MOULDING  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 7.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 69284D 8.REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG

Hide 9.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

Hide 74262 10.REMOVE REAR DOOR ARMREST COVER

Hide 67604 11.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

Hide 67628 12.REMOVE REAR DOOR TRIM BRACKET

Hide 67842E 13.REMOVE REAR DOOR SERVICE HOLE COVER

Hide 68152C 14.REMOVE REAR DOOR GLASS RUN

Hide 67408D 15.REMOVE REAR DOOR WINDOW GUIDE SUB-ASSEMBLY

Hide 67488C 16.REMOVE REAR DOOR REAR GUIDE SEAL

Hide 68104 17.REMOVE REAR DOOR GLASS SUB-ASSEMBLY

Hide 75740 18.REMOVE REAR DOOR BELT MOULDING ASSEMBLY

Hide 75762A 19.REMOVE REAR DOOR FRONT WINDOW FRAME MOULDING

HINT:

When removing the rear door front window frame moulding, heat the vehicle body and rear door front window frame moulding using a heat light.


Heating Temperature
Item Temperature
Vehicle Body 40 to 60°C (104 to 140°F)
Moulding 20 to 30°C (68 to 86°F)

NOTICE:

Do not heat the vehicle body or rear door front window frame moulding moulding excessively.


a.

Using a heat light, heat the rear door front window frame moulding.


b.
B292069E02
2.594,0.135 2.292,0.729 true 1.615,1.292 1.99,1.292 true 2.177,2.635 1.76,2.635 true 2.625,0.031 2.802,0.219 0.177,0.188 10 false *1 2.219,2.552 2.396,2.74 0.177,0.188 10 false *1 1.396,1.198 1.573,1.385 0.177,0.188 10 false *1

Using a moulding remover, disengage the clip and guide, and remove the rear door front window frame moulding.

Text in Illustration
*1 Double-sided Tape