Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › NAME PLATE › from 2017.12
RM2070E _59 Vehicle Exterior _061955 EXTERIOR PANELS / TRIM _0301933 NAME PLATE A

EXTERIOR PANELS / TRIM  NAME PLATE  REMOVAL  


CAUTION / NOTICE / HINT

HINT:

When removing the name plates or side panel emblem, heat the back door panel and name plates or side panel emblem using a heat light.

Heating Temperature
Item Temperature
Back Door Panel 40 to 60°C (104 to 140°F)
Name Plate or Back Door Emblem 20 to 30°C (68 to 86°F)


CAUTION:
·

Do not touch the heat light and heated parts, touching the heat light may result in burns.

·

Touching heated parts for a long time may result in burns.



NOTICE:

Do not heat the back door panel, back door name plates or side panel emblem excessively.


PROCEDURE

Hide 75431A 1.REMOVE NO. 1 BACK DOOR EMBLEM

a.

Remove the back door outside garnish sub-assembly.

Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>BACK DOOR OUTSIDE GARNISH>REMOVAL


b.
B275314

Disengage the 3 claws and pin to remove the No. 1 back door emblem.

NOTICE:

Be careful not to damage the back door outside garnish sub-assembly.



Hide 75442A 2.REMOVE NO. 2 BACK DOOR NAME PLATE

a.

Apply protective tape around the No. 2 back door name plate as shown in the illustration.


b.
B501341C01
0,0 0,0 false
V100155

Protective Tape


Using a moulding remover, separate the double-sided tape and remove the No. 2 back door name plate.

NOTICE:

Be careful not to damage the back door panel.



Hide 75441E 3.REMOVE NO. 1 BACK DOOR NAME PLATE

a.
B500623C01
0,0 0,0 false
V100155

Protective Tape


Apply protective tape around the No. 1 back door name plate as shown in the illustration.


b.

Using a moulding remover, separate the double-sided tape and remove the No. 1 back door name plate.

NOTICE:

Be careful not to damage the back door panel.



Hide 75374 4.REMOVE SIDE PANEL EMBLEM

HINT:

Use the same procedure for the RH side and LH side.


a.
B283941C01
0,0 0,0 false
V100155

Protective Tape


Apply protective tape around the side panel emblem as shown in the illustration.


b.

Using a moulding remover, separate the double-sided tape and disengage the 2 pins to remove the side panel emblem.

NOTICE:

Be careful not to damage the side panel.