Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER › from 2017.12
RM2070E _59 Vehicle Exterior _061955 EXTERIOR PANELS / TRIM _0301930 FRONT BUMPER A

EXTERIOR PANELS / TRIM  FRONT BUMPER  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:

When the front bumper is damaged or deformed due to an accident or contact with other objects, etc., or the bumper installation area on the body is repaired, it is necessary to perform millimeter wave radar sensor adjustment.

Click hereEngine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>ADJUSTMENT


PROCEDURE

Hide 1.INSTALL FRONT BUMPER ASSEMBLY

a.

Connect each connector.


b.
B393154

Install the front bumper assembly as shown in the illustration.


c.
B389041

Engage the 2 claws as shown in the illustration.

HINT:

Use the same procedure for the RH side and LH side.



d.

Install the 3 clips and 4 bolts.


e.

Install the 6 screws.


f.

Install the front bumper assembly with the screw.

HINT:

Use the same procedure for the RH side and LH side.



g.

w/ Pre-collision System:

i.

Connect the connector.



Hide 53289A 2.INSTALL RADIATOR SUPPORT OPENING COVER

a.

Engage the 3 guides.


b.

Install the radiator support opening cover with the 3 clips.


Hide 3.ADJUST FOG LIGHT ASSEMBLY