Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM › from 2017.12
RM2070E _54 Brake _061923 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0301683 ELECTRONICALLY CONTROLLED BRAKE SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM  C1257  Power Supply Drive Circuit  


DESCRIPTION

The skid control ECU detects a drop in accumulator pressure according to the signals from the accumulator pressure sensor, then operates and stops the motor relay as well as the pump motor.

The skid control ECU troubleshoots the built-in motor relay drive circuit, and outputs this DTC when a malfunction is detected.

DTC Code INF Code DTC Detection Condition Trouble Area
C1257 361 While accumulator pressure falls below hard pump ON pressure, the hard drive circuit does not operate for 1 second or more. Brake booster with master cylinder (Skid control ECU)
↑ 362 When hard driving, one of the 3 built-in motor relays does not operate for 0.2 seconds or more. ↑

CAUTION / NOTICE / HINT

NOTICE:

When replacing the brake booster with master cylinder (skid control ECU), perform initialization and calibration of the linear solenoid valve (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>INITIALIZATION).


HINT:

When C1241, C1242 and/or C1253 are output together with C1257, inspect and repair the trouble areas indicated by C1241, C1242 and/or C1253 first (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>C1241 or Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>C1252).


PROCEDURE

1.REPLACE BRAKE BOOSTER WITH MASTER CYLINDER
a.

Replace the brake booster with master cylinder (skid control ECU) (See page Brake>BRAKE SYSTEM (OTHER)>BRAKE BOOSTER (for LHD)>REMOVAL for LHD, or Brake>BRAKE SYSTEM (OTHER)>BRAKE BOOSTER (for RHD)>REMOVAL for RHD).



NEXT

END