Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM › from 2017.12
RM2070E _54 Brake _061923 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0301683 ELECTRONICALLY CONTROLLED BRAKE SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM  C1451  Motor Drive Permission Malfunction  


DESCRIPTION

If air bleeding has not been performed, the skid control ECU stores DTC C1451 to prevent the entry of air due to the pump motor operation.

DTC C1451 is stored when Invalid Mode is selected, the system will not return to normal until air bleeding procedure is performed.

DTC Code INF Code DTC Detection Condition Trouble Area
C1451 - Air bleeding has not been performed.
·

Brake fluid leaks

·

Air bleeding not performed



PROCEDURE

1.CHECK BRAKE FLUID LEVEL
a.

Check that the brake fluid level is sufficient.

OK:

Brake fluid level is sufficient.


HINT:
·

If the fluid level drops, check for fluid leaks, and repair as necessary.

·

If no fluid leaks exist, add and adjust fluid (See page Brake>BRAKE SYSTEM (OTHER)>BRAKE FLUID>ON-VEHICLE INSPECTION).





OK

2.PERFORM AIR BLEEDING

NG

CHECK AND REPAIR BRAKE FLUID LEAKS OR ADD FLUID

2.PERFORM AIR BLEEDING
a.

Bleed the air from the brake systems (See page Brake>BRAKE SYSTEM (OTHER)>BRAKE FLUID>BLEEDING).

HINT:

If air bleeding has been performed, this DTC will be cleared.




NEXT

3.RECONFIRM DTC
3.RECONFIRM DTC
a.

Check if the same DTC is recorded (See page ).

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>DTC CHECK / CLEAR

Result:
Result Proceed to
DTC (C1451) is output A
DTC (C1451) is not output B




A

4.CLEAR DTC

B

END