Home › Engine / Hybrid System › CRUISE CONTROL › MILLIMETER WAVE RADAR SENSOR › from 2017.12
RM2070E _51 Engine / Hybrid System _061914 CRUISE CONTROL _0301638 MILLIMETER WAVE RADAR SENSOR A

CRUISE CONTROL  MILLIMETER WAVE RADAR SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are replaced during millimeter wave radar sensor assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Millimeter wave radar sensor assembly Adjust millimeter wave radar sensor assembly
·

Dynamic radar cruise control system

·

Pre-crash safety system

·

Forward recognition camera system

·

Lane departure alert system (w/ Steering Control System)


(Click here)

PROCEDURE

Hide 53289A 1.REMOVE RADIATOR SUPPORT OPENING COVER

Hide 88211B 2.REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY

a.
E382585

Disconnect the connector.


b.
E382586C01
0,0 0,0 false
V100135

Bolt
V100136

Screw


Remove the 2 bolts and 2 screws.


c.

Disengage the 2 guides to remove the millimeter wave radar sensor assembly.

NOTICE:

Do not reuse the millimeter wave radar sensor assembly if it has been dropped or subjected to a severe impact.