The main body ECU (multiplex network body ECU) determines the status of the automatic high beam system based on the automatic high beam system signal from the forward recognition camera.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B124B | Malfunction in automatic high beam system | ·
Forward recognition camera system ·
Dynamic radar cruise control system ·
Lane departure alert system ·
Pre-crash safety system ·
Hybrid control system ·
Electronically controlled brake system ·
CAN communication system ·
Forward recognition camera ·
Main body ECU (multiplex network body ECU) |
The lighting system uses the CAN communication system. Inspect the communication functions by following How to Proceed with Troubleshooting. Troubleshoot the automatic high beam system after confirming that the communication systems are functioning properly.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Speed sensor
Yaw rate sensor
Steering sensor
CAN communication system
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: System Select / Health Check.
Check for DTCs.
| Result | Proceed to |
|---|---|
| Only DTC B124B is output | A |
| DTC B124B and other DTCs are output | B |
A
B
Check if a dynamic radar cruise control system, lane departure alert system or pre-crash safety system warning message is displayed on the multi-information display.
Click hereEngine / Hybrid System>CRUISE CONTROL>FORWARD RECOGNITION CAMERA SYSTEM>DIAGNOSIS SYSTEM
No dynamic radar cruise control system, lane departure alert system and pre-crash safety system warning messages are displayed.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereEngine / Hybrid System>CRUISE CONTROL>FORWARD RECOGNITION CAMERA SYSTEM>PROBLEM SYMPTOMS TABLE