1. PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
58410B
2.REMOVE DECK BOARD ASSEMBLY
58411A
3.REMOVE NO. 1 DECK BOARD
58412A
4.REMOVE NO. 2 DECK BOARD
64993
5.REMOVE REAR DECK FLOOR BOX
64995
6.REMOVE DECK FLOOR BOX RH
7.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
55606
8.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for LHD)
55480D
9.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY (for LHD)
55607
10.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for RHD)
Use the same procedure as for LHD (See page Vehicle Interior>INTERIOR PANELS / TRIM>LOWER INSTRUMENT PANEL>REMOVAL).
55550
11.REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY (for RHD)
Use the same procedure as for LHD (See page Vehicle Interior>INTERIOR PANELS / TRIM>LOWER INSTRUMENT PANEL>REMOVAL).
82878
12.REMOVE ECU INTEGRATION BOX LH (for RHD)
13.REMOVE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY
for LHD:
Disconnect each connector.
Disengage the claw and disconnect the connector as shown in the illustration.
Disengage the claw and disconnect the connector as shown in the illustration.
Remove the bolt and nut, and disconnect the instrument panel junction block assembly.
Disengage the 2 claws and disconnect the wiring harness protector.
for RHD:
Disengage the 2 claws and disconnect the 2 connectors as shown in the illustration.
Disconnect each connector.
Disengage the clamp.
Remove the bolt and nut, and disconnect the instrument panel junction block assembly.
Disengage the clamp.
Disengage the claw and disconnect the connector as shown in the illustration.
Disengage the claw and release the connector lock as shown in the illustration.
Disengage the claw and disconnect the connector, and remove the instrument panel junction block assembly.
89221
14.REMOVE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)
Press the claw of the junction block as shown in the illustration to release the lock.
| *1 | Main Body ECU (Multiplex Network Body ECU) |
| *2 | Claw of Driver Side Junction Block |
With the junction block lock released, insert a screwdriver with its tip wrapped with protective tape horizontally between the main body ECU (multiplex network body ECU) and junction block.
| *1 | Protective Tape |
Use a screwdriver with a diameter of between 5.0 mm (0.197 in.) and 6.3 mm (0.248 in.) and a length of approximately 90 mm (3.54 in.).
Using the screwdriver, carefully raise the main body ECU (multiplex network body ECU) up to the position where the connector becomes disengaged.
| *1 | Protective Tape |
Do not twist the screwdriver to raise the main body ECU (multiplex network body ECU).
Raise the main body ECU (multiplex network body ECU) as shown by the arrow (1), and then pull it out as shown by the arrow (2) in the illustration.
Do not touch the ECU connector.