The combination meter sub-assembly communicates with the ECM or hybrid vehicle control ECU assembly, brake booster with master cylinder assembly (skid control ECU), power steering ECU assembly, main body ECU (multiplex network body ECU), airbag ECU assembly, navigation receiver assembly*1, forward recognition camera*2 and driving support ECU assembly*2 via CAN communication.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| U0100 | When IG voltage is 9.5 V or more and the following condition is detected:
·
No communication with ECM continues for 2 seconds or more ·
No communication with hybrid vehicle control ECU continues for 3 seconds or more |
·
ECM ·
Hybrid vehicle control ECU assembly ·
CAN communication system ·
Combination meter sub-assembly |
| U0129 | When IG voltage is 9.5 V or more and the following condition is detected:
No communication with brake booster with master cylinder assembly (skid control ECU) continues for 3 seconds or more |
·
Brake booster with master cylinder assembly (Skid control ECU) ·
CAN communication system ·
Combination meter sub-assembly |
| U0131 | When IG voltage is 9.5 V or more and the following condition is detected:
No communication with power steering ECU assembly continues for 3 seconds or more |
·
Power steering ECU assembly ·
CAN communication system ·
Combination meter sub-assembly |
| U0142 | When IG voltage is 9.5 V or more and the following condition is detected:
No communication with main body ECU (multiplex network body ECU) continues for 3 seconds or more |
·
Main body ECU (Multiplex network body ECU) ·
CAN communication system ·
Combination meter sub-assembly |
| U0151 | When IG voltage is 9.5 V or more and the following condition is detected:
No communication with airbag ECU assembly continues for 10 seconds or more |
·
Airbag ECU assembly ·
CAN communication system ·
Combination meter sub-assembly |
| U0163*1 | When IG voltage is 9.5 V or more and the following condition is detected:
No communication with navigation receiver assembly continues for 3 seconds or more |
·
Navigation receiver assembly ·
CAN communication system ·
Combination meter sub-assembly |
| U023A*2 | When IG voltage is 9.5 V or more and the following condition is detected:
No communication with forward recognition camera continues for 10 seconds or more |
·
Forward recognition camera ·
CAN communication system ·
Combination meter sub-assembly |
| U1104*2 | When IG voltage is 9.5 V or more and the following condition is detected:
No communication with driving support ECU assembly continues for 10 seconds or more |
·
Driving support ECU assembly ·
CAN communication system ·
Combination meter sub-assembly |
*1: for Navigation receiver type
*2: w/ Forward Recognition Camera
Check if CAN communication DTCs are output (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (w/ Central Gateway ECU)>DIAGNOSIS SYSTEM).(w/ Central Gateway ECU)
Check if CAN communication DTCs are output (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (w/o Central Gateway ECU)>DIAGNOSIS SYSTEM).(w/o Central Gateway ECU)
| Result | Proceed to |
|---|---|
| DTCs are output (w/ Central Gateway ECU) | A |
| DTCs are output (w/o Central Gateway ECU) | B |
| DTCs are not output | C |
A
B
C
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)