| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| U0129 | No communication from the brake booster with master cylinder assembly (skid control ECU) continues. | ·
Brake booster with master cylinder assembly (skid control ECU) branch line or connector ·
Power source circuit of brake booster with master cylinder assembly (skid control ECU) ·
Brake booster with master cylinder assembly (skid control ECU) ground circuit ·
Brake booster with master cylinder assembly (skid control ECU) |
This diagnostic procedure is for when DTC U0129 is output only by the hybrid vehicle control ECU (GTS display: Hybrid Control).
Before measuring the resistance of the CAN bus, turn the power switch off and leave the vehicle for 1 minute or more without operating the key or any switches, or opening or closing the doors. After that, disconnect the cable from the negative (-) auxiliary battery terminal and leave the vehicle for 1 minute or more before measuring the resistance.
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
Because the order of diagnosis is important to allow correct diagnosis, make sure to begin troubleshooting using How to Proceed with Troubleshooting when CAN communication system related DTCs are output (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (w/ Central Gateway ECU)>HOW TO PROCEED WITH TROUBLESHOOTING).
After the repair, perform the CAN bus check and check that all the ECUs and sensors connected to the CAN communication system are displayed (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (w/ Central Gateway ECU)>DIAGNOSIS SYSTEM).
Inspect the fuses for circuits related to this system before performing the following procedure.
Before disconnecting related connectors for inspection, push in on each connector body to check that the connector is not loose or disconnected.
When a connector is disconnected, check that the terminals and connector body are not cracked, deformed or corroded.
Reconfirm DTCs.
If the hybrid vehicle control ECU outputs DTC U0100 and DTC U0129, check the branch circuit of sub bus 15.
| Result | Proceed to |
|---|---|
| The hybrid vehicle control ECU outputs only DTC U0129.
(GTS display: Hybrid Control) |
A |
| The hybrid vehicle control ECU outputs DTC U0100 and U0129.
(GTS display: Hybrid Control) |
B |
A
B
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Chassis / ABS/VSC/TRC / Trouble Codes.
| Result | Proceed to |
|---|---|
| DTC C1241 is not output. | A |
| DTC C1241 is output. | B |
A
B
(See pageBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>C1241)
Disconnect the cable from the negative (-) auxiliary battery terminal.
Disconnect the A58 brake booster with master cylinder assembly (skid control ECU) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A58-35 (CA2H) - A58-34 (CA2L) | Cable disconnected from negative (-) auxiliary battery terminal | 54 to 69 Ω |
| *a | Front view of wire harness connector
(to Brake Booster with Master Cylinder Assembly (Skid Control ECU)) |
| Result | Proceed to |
|---|---|
| OK (for LHD) | A |
| OK (for RHD) | B |
| NG | C |
A
B
C