Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › INTELLIGENT PARKING ASSIST SYSTEM › from 2020.08
RM2070E _56 Audio / Visual / Telematics _061933 PARK ASSIST / MONITORING _0301741 INTELLIGENT PARKING ASSIST SYSTEM C

PARK ASSIST / MONITORING  INTELLIGENT PARKING ASSIST SYSTEM  C1621  Back Camera Power Supply Failure  C1622  Open or Short Circuit in Back Camera Signal  


DESCRIPTION

These DTCs are stored if the parking assist ECU judges as a result of its self check that the signals or signal lines between the parking assist ECU and rear television camera assembly are not normal.

DTC No. DTC Detection Condition Trouble Area
C1621 Rear television camera power supply failure
·

Harness or connector

·

Rear television camera assembly

·

Parking assist ECU


C1622 An open or short in the rear television camera signal circuit
·

Harness or connector

·

Rear television camera assembly

·

Parking assist ECU



WIRING DIAGRAM

E267063E61
2.292,0.531 2.615,0.74 0.323,0.208 10 false 15 2.271,1.115 2.729,1.313 0.458,0.198 10 false L65 2.271,1.51 2.729,1.708 0.458,0.198 10 false L65 2.271,1.906 2.729,2.104 0.458,0.198 10 false L65 2.281,2.292 2.74,2.49 0.458,0.198 10 false L64 1.854,0.708 2.313,0.906 0.458,0.198 10 false CV+ 1.854,1.094 2.313,1.292 0.458,0.198 10 false CB+ 1.875,1.5 2.333,1.698 0.458,0.198 10 false CV- 1.729,1.896 2.25,2.115 0.521,0.219 10 false CGND 1.75,2.302 2.271,2.521 0.521,0.219 10 false GND1 2.302,0.927 2.625,1.135 0.323,0.208 10 false 14 2.313,1.323 2.635,1.531 0.323,0.208 10 false 38 2.313,1.719 2.635,1.927 0.323,0.208 10 false 37 2.271,0.719 2.729,0.917 0.458,0.198 10 false L65 0.969,2.625 2.667,3.063 1.698,0.438 10 false Parking Assist ECU 2.354,2.115 2.677,2.323 0.323,0.208 10 false 4 4.844,0.625 5.167,0.833 0.323,0.208 10 false 3 4.844,1.021 5.167,1.229 0.323,0.208 10 false 6 4.844,1.417 5.146,1.635 0.302,0.219 10 false 2 4.844,1.813 5.167,2.021 0.323,0.208 10 false 5 5.021,0.708 5.479,0.906 0.458,0.198 10 false CV+ 5.021,1.115 5.479,1.313 0.458,0.198 10 false CB+ 5.031,1.51 5.5,1.75 0.469,0.24 10 false CV- 5.021,1.896 5.542,2.115 0.521,0.219 10 false CGND 4.833,2.219 5.292,2.417 0.458,0.198 10 false V14 4.833,2.385 6.333,2.917 1.5,0.531 10 false Rear Television Camera Assembly 3.344,3.146 5.177,3.344 1.833,0.198 10 false *: Shielded 3.531,1.698 3.844,1.896 0.313,0.198 10 false *

CAUTION / NOTICE / HINT

NOTICE:
·

When the "System initializing" message is displayed on the navigation receiver assembly after the auxiliary battery cable has been disconnected, correct the steering angle neutral point (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>INITIALIZATION).

·

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the intelligent parking assist system may be needed (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>CALIBRATION).



PROCEDURE

1.CHECK HARNESS AND CONNECTOR (PARKING ASSIST ECU - REAR TELEVISION CAMERA ASSEMBLY)
a.

Disconnect the L65 parking assist ECU connector.


b.

Disconnect the V14 rear television camera assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
L65-14 (CB+) - V14-6 (CB+) Always Below 1 Ω
L65-15 (CV+) - V14-3 (CV+) Always Below 1 Ω
L65-37 (CGND) - V14-5 (CGND) Always Below 1 Ω
L65-38 (CV-) - V14-2 (CV-) Always Below 1 Ω
L65-14 (CB+) - Body ground Always 10 kΩ or higher
L65-15 (CV+) - Body ground Always 10 kΩ or higher
L65-37 (CGND) - Body ground Always 10 kΩ or higher
L65-38 (CV-) - Body ground Always 10 kΩ or higher




OK

2.INSPECT PARKING ASSIST ECU (CGND, CB+)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.INSPECT PARKING ASSIST ECU (CGND, CB+)
a.
U191305E02
1.094,1.115 1.323,1.656 false 1.104,0.969 1,0.281 1,0.281 0.906,0.281 false 0.094,0.052 0.292,0.219 0.198,0.167 10 false *a 1.115,1.677 1.552,1.844 0.438,0.167 10 false CGND 0.583,0.198 0.917,0.365 0.333,0.167 10 false CB+ 1.646,0.156 1.979,0.333 0.333,0.177 10 false L65

Reconnect the L65 parking assist ECU connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
L65-37 (CGND) - Body ground Always Below 1 Ω


Text in Illustration
*a Component with harness connected
(Parking Assist ECU)


c.

Measure the voltage according to the value(s) in the table below.


Standard Voltage:
Tester Connection Condition Specified Condition
L65-14 (CB+) - L65 - 37 (CGND) Power switch on (ACC) 5.5 to 7.05 V



OK

3.INSPECT REAR TELEVISION CAMERA ASSEMBLY (CV+, GND1)

NG

3.INSPECT REAR TELEVISION CAMERA ASSEMBLY (CV+, GND1)
a.

Reconnect the V14 rear television camera assembly connector.


b.

Reconnect the L65 parking assist ECU connector.

E361817E01
1.5,1.167 1.917,1.417 0.417,0.25 2.667,1.167 3.083,1.417 0.417,0.25 1.365,2.49 1.365,1.896 false 2.604,2.49 2.604,1.875 false 4.833,1.917 5,1.917 5,1.917 5.063,1.51 false 5.417,1.917 5.25,1.917 5.25,1.917 5.156,1.417 false 4.833,3.583 5,3.583 5,3.583 5.094,3.042 false 5.5,3.583 5.333,3.583 5.333,3.583 5.208,2.99 false 0.729,0.906 1.042,1.104 0.313,0.198 10 false *a 1.24,2.521 1.552,2.719 0.313,0.198 10 false CV+ 2.458,2.521 2.896,2.719 0.438,0.198 10 false GND1 1.583,1.208 1.896,1.406 0.313,0.198 10 false L65 2.75,1.208 3.063,1.406 0.313,0.198 10 false L64 4.229,0.229 4.542,0.427 0.313,0.198 10 false *b 4.656,1.833 4.969,2.031 0.313,0.198 10 false *d 5.458,1.833 5.771,2.031 0.313,0.198 10 false *e 4.354,1.031 4.792,1.229 0.438,0.198 10 false GND 4.375,2.698 4.813,2.896 0.438,0.198 10 false GND 4.25,2.042 4.563,2.24 0.313,0.198 10 false *c 4.646,3.5 4.958,3.698 0.313,0.198 10 false *d 5.531,3.49 5.844,3.688 0.313,0.198 10 false *e


c.

Using an oscilloscope, check the waveform of the rear television camera assembly.

HINT:

A waterproof connector is used for the rear television camera assembly. Therefore, inspect the waveform at the parking assist ECU with the connector connected.


OK:

Waveform is similar to that shown in the illustration.


Item Content
Measurement Terminal L65-15 (CV+) - L64-4 (GND1)
Measurement Setting 200 mV/DIV., 50 μs./DIV.
Condition Power switch on (IG), reverse (R) selected

HINT:
·

The video waveform changes according to the image sent by the rear television camera assembly.

·

The video waveform is constantly output when the power switch is on (ACC).



Text in Illustration
*a Component with harness connected
(Parking Assist ECU)
*b Waveform 1 (camera lens not covered, displaying an image)
*c Waveform 2 (camera lens covered, blacking out the screen)
*d Synchronization Signal
*e Video Waveform



OK

NG

REPLACE REAR TELEVISION CAMERA ASSEMBLY