Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING ASSIST ECU › from 2020.08
RM2070E _56 Audio / Visual / Telematics _061933 PARK ASSIST / MONITORING _0301746 PARKING ASSIST ECU A

PARK ASSIST / MONITORING  PARKING ASSIST ECU  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 7.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 55480D 8.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY

Hide 82877 9.REMOVE ECU INTEGRATION BOX RH

a.

Disconnect each connector.


b.
E349654

Disengage each clamp.


c.

Remove the bolt, nut and ECU integration box RH.


Hide 86792C 10.REMOVE PARKING ASSIST ECU

a.
E349656

Disengage the claw and remove the parking assist ECU.

HINT:

When removing the parking assist ECU, if the bracket for the driving support ECU assembly is on top of the bracket for the parking assist ECU, remove the driving support ECU assembly first (See page Engine / Hybrid System>CRUISE CONTROL>DRIVING SUPPORT ECU>REMOVAL).