Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › INTELLIGENT PARKING ASSIST SYSTEM › from 2020.08
RM2070E _56 Audio / Visual / Telematics _061933 PARK ASSIST / MONITORING _0301741 INTELLIGENT PARKING ASSIST SYSTEM C

PARK ASSIST / MONITORING  INTELLIGENT PARKING ASSIST SYSTEM  C168D  Vehicle Information Unmatched  


DESCRIPTION

This DTC is stored when the parking assist ECU judges as a result of its self check that the vehicle information received from the main body ECU (multiplex network body ECU) via CAN communication and the vehicle information stored in the rear television camera assembly do not match.

DTC No. DTC Detection Condition Trouble Area
C168D Vehicle Information is Unmatched
·

Rear television camera assembly optical axis adjustment (back camera position setting)

·

Steering angle setting

·

Parking assist ECU



CAUTION / NOTICE / HINT

NOTICE:
·

When the "System initializing" message is displayed on the navigation receiver assembly after the auxiliary battery cable has been disconnected, correct the steering angle neutral point (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>INITIALIZATION).

·

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the intelligent parking assist system may be needed (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>CALIBRATION).



PROCEDURE

1.PERFORM CALIBRATION
a.

Perform the following procedure depending on the memory conditions to register the vehicle information into the rear television camera assembly.

i.

Rear television camera assembly optical axis adjustment (back camera position setting) (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>CALIBRATION).





NEXT

2.CHECK DTC OUTPUT
2.CHECK DTC OUTPUT

b.

Recheck for DTCs and check that no DTCs are output (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>DTC CHECK / CLEAR).

HINT:
·

If DTC C168D is output, perform the procedure to allow the intelligent parking assist ECU to store the vehicle information again.

·

If DTC C168D is still output after performing the procedure to make the intelligent parking assist ECU store the vehicle information 3 times, replace the intelligent parking assist ECU.



Result:
Result Proceed to
DTC C168D is output A
DTC C168D is not output B




A

B

END