Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM › from 2020.08
RM2070E _54 Brake _061923 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0301683 ELECTRONICALLY CONTROLLED BRAKE SYSTEM J

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM  Brake Control Warning Light does not Come ON  


DESCRIPTION

The skid control ECU is connected to the combination meter sub-assembly via CAN communication.

CAUTION / NOTICE / HINT

NOTICE:

When replacing the brake booster with master cylinder (skid control ECU), perform initialization and calibration of the linear solenoid valve (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>INITIALIZATION).


PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
a.

Result:
Result Proceed to
DTC is not output A
DTC is output B



A

2.PERFORM ACTIVE TEST USING GTS (BRAKE WARNING LIGHT / YELLOW (MINOR MALFUNCTION))

B

2.PERFORM ACTIVE TEST USING GTS (BRAKE WARNING LIGHT / YELLOW (MINOR MALFUNCTION))
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Select the Active Test on the GTS (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>DATA LIST / ACTIVE TEST).

ABS/VSC/TRC
Tester Display Test Part Control Range Diagnostic Note
ECB* Warning Light Brake warning light / yellow (minor malfunction) Warning light ON/OFF Observe combination meter sub-assembly

*: Electronically Controlled Brake System


d.

Check that the brake warning light / yellow (minor malfunction) on the combination meter sub-assembly turns on or off in accordance with the GTS operation.

OK:

The brake warning light / yellow (minor malfunction) turns on or off in accordance with the GTS operation.


Result:
Result Proceed to
OK (for LHD) A
OK (for RHD) B
NG C


HINT:

If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing the part (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>PROBLEM SYMPTOMS TABLE).




A

REPLACE BRAKE BOOSTER WITH MASTER CYLINDER

B

REPLACE BRAKE BOOSTER WITH MASTER CYLINDER

C

3.INSPECT COMBINATION METER SUB-ASSEMBLY
3.INSPECT COMBINATION METER SUB-ASSEMBLY
a.

Turn the power switch off (lock).


b.

Perform the Active Test of the combination meter sub-assembly (meter CPU) using the GTS (See page Vehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DATA LIST / ACTIVE TEST).


c.

Check the combination meter sub-assembly.

OK:

The brake warning light / yellow (minor malfunction) turns on or off in accordance with the GTS operation.


Result:
Result Proceed to
OK (for LHD) A
OK (for RHD) B
NG (w/ Multi-information Display) C
NG (w/o Multi-information Display) D


HINT:

If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing the part (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>PROBLEM SYMPTOMS TABLE).




A

REPLACE BRAKE BOOSTER WITH MASTER CYLINDER

B

REPLACE BRAKE BOOSTER WITH MASTER CYLINDER

C

REPLACE COMBINATION METER SUB-ASSEMBLY

D