The windshield wiper relay assembly controls the windshield wiper motor assembly.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Remove the windshield wiper motor assembly (See pageVehicle Exterior>WIPER / WASHER>FRONT WIPER MOTOR>REMOVAL).
Remove the windshield wiper motor assembly (See page ).
Check the LO operation.
Connect a auxiliary battery positive (+) lead to terminal 1 (+1) and a negative (-) lead to terminal 2 (E), and check that the motor operates at low speed.
Motor operates at low speed (LO).
Check the HI operation.
Connect a auxiliary battery positive (+) lead to terminal 4 (+2) and a negative (-) lead to terminal 2 (E), and check that the motor operates at high speed.
Motor operates at high speed (HI).
| *a | Component without harness connected
(Windshield Wiper Motor Assembly) |
OK
NG
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A35-3 (B) - Body ground | Power switch on (IG) | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A35-2 (E) - Body ground | Always | Below 1 Ω |
OK
NG
Disconnect the L146 windshield wiper relay assembly connector and L48 windshield wiper switch assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A35-1 (+1) - L48-3 (+1) | Always | Below 1 Ω |
| A35-1 (+1) - Body ground | Always | 10 kΩ or higher |
| A35-4 (+2) - L146-11 (+2) | Always | Below 1 Ω |
| A35-4 (+2) - L48-4 (+2) | Always | Below 1 Ω |
| A35-4 (+2) - Body ground | Always | 10 kΩ or higher |
| A35-5 (+S) - L146-1 (+SM) | Always | Below 1 Ω |
| A35-5 (+S) - Body ground | Always | 10 kΩ or higher |
OK
NG