DTC P0106 Manifold Absolute Pressure / Barometric Pressure Circuit Range / Performance Problem |

| DTC No. | DTC Detection Condition | Trouble Area |
| P0106 | Intake manifold pressure measured after engine start drops by less than 3 kPa [22.5 mmHg] compared to the intake manifold pressure (atmospheric pressure) measured before engine start (2 trip detection logic). |
|
| Related DTCs | P0106: Manifold absolute pressure sensor stuck |
| Required Sensors/Components (Main) | Manifold absolute pressure sensor |
| Required Sensors/Components (Related) | - |
| Frequency of Operation | Continuous |
| Duration | 6 seconds |
| MIL Operation | 2 driving cycles |
| Sequence of Operation | None |
| Monitor runs whenever the following DTCs are not stored | P0010 (VVT oil control valve) P0011 (VVT system - advance) P0012 (VVT system - retard) P0016 (VVT system - misalignment) P0107, P0108 (Manifold absolute pressure) P0112, P0113 (Intake air temperature sensor) P0115, P0117, P0118 (Engine coolant temperature sensor) P0120, P0121, P0122, P0123, P0220, P0222, P0223, P2135 (Throttle position sensor) P0125 (Insufficient coolant temperature for closed loop fuel control) P0335 (Crankshaft position sensor) P0401 (EGR system (closed)) P106A (Evaporative emission control system pressure sensor - Manifold pressure sensor correlation) |
| Auxiliary battery voltage | 10.5 V or higher |
| Engine coolant temperature | 30°C (86°F) or higher |
| Intake air temperature | -10°C (14°F) or higher |
| Engine speed | 1000 rpm or more |
| Throttle valve | Close |
| EGR valve | Close |
| Atmospheric pressure | 76 kPa(abs) [570 mmHg(abs)] or higher |
| Difference between manifold absolute pressure and atmospheric pressure | Higher than -3 kPa [-22.5 mmHg] |
| Techstream Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.CHECK ANY OTHER DTC OUTPUT (IN ADDITION TO DTC P0106) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON (IG) and turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| DTC P0106 is output | A |
| DTC P0106 and other DTCs are output | B |
|
| ||||
| A | |
| 2.READ VALUE USING TECHSTREAM (MAP) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON (IG) and turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Data List / Primary / MAP.
Read the MAP value at ignition switch to ON (IG).
Put the engine in inspection mode (maintenance mode) (Click here).
Start the engine and warm it up.
Read the MAP value at idling.
| Engine condition | Techstream Display |
| Ignition switch ON (IG) | 80 to 110 kPa(abs) [600 or 825 mmHg(abs)] |
| Idling | 20 to 40 kPa(abs) [150 to 300 mmHg(abs)] |
|
| ||||
| OK | ||
| ||
| 3.CHECK INTAKE SYSTEM |
Check the intake system for vacuum leaks (Click here).
|
| ||||
| OK | ||
| ||