VEHICLE PROXIMITY NOTIFICATION SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING |
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.CUSTOMER PROBLEM ANALYSIS AND SYMPTOM CHECK |
| |||||
| 3.INSPECT AUXILIARY BATTERY VOLTAGE |
Measure the auxiliary battery voltage with the ignition switch off.
| |||||
| 4.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* |
Using the Techstream to check if the CAN communication system is functioning normally.
| Result | Proceed to |
| CAN DTC is not output | A |
| CAN DTC is output | B |
|
| ||||
| |||||
| 5.CHECK FUNCTION OF LIGHTING SYSTEM (EXT) |
Check whether the lighting system is functioning normally (Click here).
| Result | Proceed to |
| Lighting system is functioning normally | A |
| Lighting system is not functioning normally | B |
|
| ||||
| |||||
| 6.CHECK METER / GAUGE SYSTEM* |
Using the Techstream to check if the meter/gauge system is functioning normally.
| Result | Proceed to |
| No vehicle speed signal is mistakenly received | A |
| A vehicle speed signal is mistakenly received | B |
|
| ||||
| |||||
| 7.CHECK HYBRID CONTROL SYSTEM |
Check whether the hybrid control system is functioning normally (Click here).
| Result | Proceed to |
| Hybrid control system is functioning normally | A |
| Hybrid control system is not functioning normally | B |
|
| ||||
| |||||
| 8.CHECK FOR DTC* |
Check for DTCs (Click here).
Clear the DTCs (Click here).
Recheck for DTCs (Click here).
| Result | Proceed to |
| DTCs are output | A |
| DTCs are not output | B |
|
| ||||
| |||||
| 9.PROBLEM SYMPTOMS TABLE |
| Result | Proceed to |
| Fault is not listed in Problem Symptoms Table | A |
| Fault is listed in Problem Symptoms Table | B |
|
| ||||
| |||||
| 10.OVERALL ANALYSIS AND TROUBLESHOOTING |
Data List / Active Test (Click here)
Terminals of ECU (Click here)
Inspection
| |||||
| 11.REPAIR OR REPLACE |
| |||||
| 12.CONFIRMATION TEST |
|
| ||||
|---|---|---|---|---|---|