DTC P0560 System Voltage |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0560 | An open in the ECM back up power source circuit (1 trip detection logic). |
|
| Related DTCs | P0560: ECM system voltage range check/rationality |
| Required Sensors/Components (Main) | ECM |
| Required Sensors/Components (Related) | - |
| Frequency of Operation | Continuous |
| Duration | 3 seconds |
| MIL Operation | Immediate |
| Sequence of Operation | None |
| Monitor runs whenever the following DTCs are not stored | None |
| Both of the following conditions are met | - |
| Continuous auxiliary battery voltage | Less than 3.5 V |
| Stand-by RAM | Initialized |
| Techstream Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|

| 1.INSPECT AUXILIARY BATTERY |
Inspect that the auxiliary battery is not depleted .
|
| ||||
| OK | |
| 2.CHECK AUXILIARY BATTERY TERMINAL |
Check that the auxiliary battery terminals are not loose or corroded.
|
| ||||
| OK | |
| 3.CHECK TERMINAL VOLTAGE (POWER SOURCE OF ECM) |
![]() |
Disconnect the ECM connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A40-1 (BATT) - Body ground | Ignition switch off | 11 to 16 V |
| *a | Front view of wire harness connector (to ECM) |
|
| ||||
| OK | |
| 4.CHECK WHETHER DTC OUTPUT RECURS (DTC P0560) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON (IG).
Turn the Techstream on.
Clear the DTCs (Click here).
Turn the ignition switch off and wait for at least 30 seconds.
Turn the ignition switch to ON (IG).
Turn the Techstream on.
Wait 5 seconds or more.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| DTC P0560 is output | A |
| DTC is not output | B |
|
| ||||
| A | ||
| ||