ECM > REMOVAL |
| 1. PRECAUTION |
| 2. REMOVE FRONT FLOOR COVER RH |
![]() |
Using a clip remover, remove the 2 clips <A>.
Disengage the 3 clips <B>.
![]() |
Disengage the 3 guides and remove the front floor cover RH.
| 3. DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL |
| 4. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY |
| 5. REMOVE INNER COWL TOP TO COWL BRACE |
![]() |
Remove the 3 bolts and inner cowl top to cowl brace.
| 6. REMOVE FRONT AIR SHUTTER SEAL |
![]() |
Disengage the clamp to remove the front air shutter seal.
| 7. REMOVE FRONT NO. 1 VENTILATOR SEAL |
![]() |
Disengage the clamp to remove the front No. 1 ventilator seal.
| 8. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY |
![]() |
Disengage the clamp to separate the wire harness from the outer cowl top panel sub-assembly.
![]() |
Remove the 8 bolts, nut and outer cowl top panel sub-assembly.
| 9. REMOVE ECM |
![]() |
Push the locks on the 2 levers, then raise the levers, and disconnect the 2 ECM connectors.
![]() |
Remove the bolt and nut.
Remove the ECM.
![]() |
Remove the nut.
![]() |
Remove the 4 screws, ECM cover and No. 2 ECM bracket.