Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SPIRAL CABLE

SPIRAL CABLE > REMOVAL

for Preparation Click here



1. REMOVE STEERING WHEEL ASSEMBLY
(Click here)


2. REMOVE LOWER STEERING COLUMN COVER


    C248042
  1. Remove the 3 screws.



    C256915
  1. Disengage the 4 claws and remove the lower steering column cover.



3. REMOVE UPPER STEERING COLUMN COVER


C248044
  1. Disengage the 2 claws and remove the upper steering column cover.



4. REMOVE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

NOTICE:
  1. Do not replace the spiral cable with sensor sub-assembly with the negative (-) auxiliary battery cable connected and the ignition switch on (IG).
  2. Do not rotate the spiral cable with sensor sub-assembly without the steering wheel with the negative (-) auxiliary battery cable connected and the ignition switch on (IG).
  3. Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.
  4. Do not remove the spiral cable from the steering sensor.



    B289075E01
  1. Slide the slider to release the lock, and then disconnect the yellow airbag connector from the spiral cable with sensor sub-assembly.
    Text in Illustration 
    *a
    Slider

    NOTICE:
    When disconnecting any airbag connector, take care not to damage the airbag wire harness.

  1. Disconnect the other connector from the spiral cable with sensor sub-assembly.



    B296307
  1. Disengage the 3 claws to remove the spiral cable with sensor sub-assembly.