FRONT AIRBAG SENSOR > INSTALLATION |
| 1. INSTALL FRONT AIRBAG SENSOR |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
Before connecting the connector, check that the position of the white housing lock is correct as shown in the illustration.

| *a | Incorrect | *b | Correct |
Insert the pin (stopper) into the body hole and install the front airbag sensor to the vehicle body with the nut.
Connect the connector to the front airbag sensor.
Be sure to engage the connectors until they are locked (when locking, make sure that a click sound can be heard).

| *1 | White Housing Lock | *2 | Yellow CPA |
| *a | Connection is Completed | - | - |
Check that there is no looseness in the installation parts of the front airbag sensor.
| 2. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL |
| 3. INSTALL FRONT FLOOR COVER RH |
Engage the 3 guides.
![]() |
Engage the 3 clips <B> to install the front floor cover RH.
Install the 2 clips <A>.
| 4. INSTALL HEADLIGHT ASSEMBLY |
| 5. PERFORM DIAGNOSTIC SYSTEM CHECK |
| 6. INSPECT SRS WARNING LIGHT |