SRS SEAT CUSHION AIRBAG ASSEMBLY > DISPOSAL |
| 1. PRECAUTION |
| 2. DISPOSE OF FRONT SEAT AIRBAG SUB-ASSEMBLY (When Installed in Vehicle) |
![]() |
Check the function of SST .
Refer to Precaution (Click here).
Disconnect the cable from the negative (-) auxiliary battery terminal.
Disconnect the connector from the front seat airbag sub-assembly under the front seat assembly.
Slide the slider to release the lock, and then disconnect the yellow airbag connector as shown in the illustration.

| *a | Slider | - | - |
Install SST.
![]() |
Connect the SST connector to the front seat airbag sub-assembly connector.
![]() |
Move SST at least 10 m (32.8 ft.) away from the front side window.
| *1 | 12 V Battery |
| *a | 10 m (32.8 ft.) or more |
Maintaining sufficient clearance for the SST wire harness in the front side window, close all doors and windows of the vehicle.
Connect the red clip of SST to the positive (+) battery terminal and the black clip of SST to the negative (-) battery terminal.
Deploy the airbag.
Check that no one is inside the vehicle or within a 10 m (32.8 ft.) radius of the vehicle.
Press the SST activation switch to deploy the airbag.
| 3. DISPOSE OF FRONT SEAT AIRBAG SUB-ASSEMBLY (When Not Installed in Vehicle) |
![]() |
Check the function of SST .
Remove the front seat airbag sub-assembly (Click here).
![]() |
Using braided wire, tie down the front seat airbag sub-assembly to an unneeded tire.
| *1 | Stripped Wire Section |
| *a | Wire Diameter |
![]() |
Install the 2 nuts to the front seat airbag sub-assembly.
![]() |
Wind the wires around the front seat airbag sub-assembly as shown in the illustration.
![]() |
Position the front seat airbag sub-assembly inside the tire.
| *a | Width |
| *b | Inner Diameter |
Install SST.
![]() |
Connect the SST connector to the front seat airbag sub-assembly connector.
Place the tires.
![]() |
Place at least 2 tires under the tire to which the front seat airbag sub-assembly is tied.
| *1 | Tires (2 or more) |
| *a | Inner Diameter |
| *b | Width |
Place at least 2 tires onto the tire to which the front seat airbag sub-assembly is tied. The top tire should have a wheel installed.
![]() |
Tie the tires together with the 2 wires.
Install SST.
![]() |
Connect the SST connector.
| *1 | Front Seat Airbag Sub-assembly |
| *2 | 12 V Battery |
| *a | 10 m (32.8 ft.) or more |
Move SST at least 10 m (32.8 ft.) away from the airbag tied down to the tire.
Deploy the airbag.
Connect the red clip of SST to the positive (+) battery terminal and the black clip of SST to the negative (-) battery terminal.
Check that no one is within a 10 m (32.8 ft.) radius of the tire to which the front seat airbag sub-assembly is tied.
Press the SST activation switch to deploy the airbag.
Dispose of the front seat airbag sub-assembly.
Remove the front seat airbag sub-assembly from the tire.
Place the front seat airbag sub-assembly in a plastic bag, tie it tightly, and dispose of it according to local regulations.