Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SRS SEAT CUSHION AIRBAG ASSEMBLY

SRS SEAT CUSHION AIRBAG ASSEMBLY > REMOVAL

for Preparation Click here


CAUTION:
  1. Be sure to read Precaution thoroughly before servicing (Click here).
  2. Wear protective gloves. Sharp areas on the seat frame and adjuster may injure your hands.
  3. If the cushion airbag was deployed, replace the front seat airbag sub-assembly, separate type front seat cushion spring assembly, separate type front seat cushion cover and separate type front seat cushion pad with the necessary parts in accordance with the extent of the collision damage.
    w/ Non-removable Headrest: (Click here)
    w/ Removable Headrest: (Click here)

HINT:
Use the same procedure for the LH side and RH side.



1. REMOVE FRONT SEAT ASSEMBLY
w/ Non-removable Headrest: (Click here)
w/ Removable Headrest: (Click here)


2. DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER
w/ Non-removable Headrest:
w/ Removable Headrest:


3. DISCONNECT AIRBAG WIRE HARNESS


  1. for Driver Side:



      B300274
    1. Disengage the claw and 4 clamps to separate the airbag wire harness.



  1. for Front Passenger Side:



      B300231
    1. Disengage the claw and clamp.

    2. Disconnect the airbag wire harness from the seat clamp.



4. REMOVE RECLINING ADJUSTER RELEASE HANDLE
w/ Non-removable Headrest:
w/ Removable Headrest:


5. REMOVE VERTICAL ADJUSTING HANDLE (w/ Vertical Adjuster)


    B301362
  1. Remove the screw and vertical adjusting handle.



6. REMOVE FRONT SEAT CUSHION SHIELD
w/ Non-removable Headrest:
w/ Removable Headrest:


7. REMOVE FRONT SEAT LOWER CUSHION SHIELD (w/ Vertical Adjuster)


    B301365
  1. Disengage the 2 claws to remove the front seat lower cushion shield.



8. REMOVE FRONT SEAT INNER CUSHION SHIELD (for Driver Side)
w/ Non-removable Headrest:
w/ Removable Headrest:


9. REMOVE FRONT SEAT INNER CUSHION SHIELD (for Front Passenger Side)
w/ Non-removable Headrest:
w/ Removable Headrest:


10. REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD (w/ Non-removable Headrest)


    B299150
  1. Disengage each hook and remove the separate type front seat cushion cover with pad.



11. REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD (w/ Removable Headrest)
w/o Seat Heater System:
w/ Seat Heater System:


12. REMOVE FRONT SEAT AIRBAG SUB-ASSEMBLY


    B300232
  1. Disengage the 2 clamps.

  1. Remove the 3 nuts and the front seat airbag sub-assembly.

    CAUTION:
    1. The nuts must not be reused.
    2. Make sure that the separate type front seat cushion spring assembly is not deformed. If it is, replace it with a new one.