Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › CURTAIN SHIELD AIRBAG ASSEMBLY

CURTAIN SHIELD AIRBAG ASSEMBLY > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The procedure listed below is for the LH side.



1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY
  1. Check that the ignition switch is off.

  1. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



    B296251E01
  1. Temporarily install the curtain shield airbag assembly with the 3 hooks as shown in the illustration.

  1. Engage the hook (A).

    NOTICE:
    1. When installing the curtain shield airbag assembly, have assistants hold it to prevent it from bending.
    2. Do not twist the curtain shield airbag assembly when installing it.



  1. Install the curtain shield airbag assembly to the body panel with a new bolt, the 4 clips, 7 new clips and 3 new spacers in the order shown in the illustration.

    Torque:
    14 N*m{ 143 kgf*cm , 10 ft.*lbf }



    B296249E01


    Text in Illustration 
    *1
    Pin
    *2
    Clip
    *3
    Curtain Shield Airbag Assembly
    *4
    Body Panel
    *5
    Spacer
    -
    -

  1. Push in 7 new pins to each clip.

    NOTICE:
    Make sure that the pins of the clips are pushed in firmly.



    B296246E01
  1. Connect the curtain shield airbag connector.
    Text in Illustration 
    *1
    Airbag Connector
    *2
    Airbag Connector Lock

    NOTICE:
    When connecting any airbag connector, take care not to damage the airbag wire harness.

  1. Push in the airbag connector lock to install the curtain shield airbag connector.



2. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. INSTALL ROOF HEADLINING ASSEMBLY
(Click here)


4. PERFORM DIAGNOSTIC SYSTEM CHECK
(Click here)


5. INSPECT SRS WARNING LIGHT
(Click here)