POWER STEERING SYSTEM > ON-VEHICLE INSPECTION |
| 1. CHECK STEERING EFFORT (TORQUE) |
Stop the vehicle on a level, paved surface and align the wheels straight ahead.
Remove the horn button assembly (Click here).
Connect the cable to the negative (-) auxiliary battery terminal.
Using a torque wrench, check that the steering wheel set nut is properly tightened.
Turn the ignition switch to on (READY) so that the power steering is ready to operate.
Turn the steering wheel 90 degrees to the right and check steering effort (torque) with the steering wheel turned. Check in the opposite direction using the same manner.
Align the front wheels facing straight ahead.
Turn the ignition switch off.
Disconnect the cable from the negative (-) auxiliary battery terminal.
Install the horn button assembly (Click here).