Home › Engine / Hybrid System › 1NZ-FXE COOLING › COOLING FAN SYSTEM

COOLING FAN SYSTEM > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT COOLING FAN SYSTEM
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON (IG).

  1. Turn the Techstream on.

  1. Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Electric Cooling Fan.

  1. Check the operation of the cooling fans while operating them using the Techstream.
    If the cooling fan motor does not operate, check the cooling fan circuit (Click here).