SFI SYSTEM > Fuel Injector Circuit |


| 1.CHECK TERMINAL VOLTAGE (POWER SOURCE OF FUEL INJECTOR ASSEMBLY) |
![]() |
Disconnect the fuel injector assembly connectors.
Turn the ignition switch to ON (IG).
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| C1-2 - Body ground | Ignition switch ON (IG) | 11 to 14 V |
| C2-2 - Body ground | Ignition switch ON (IG) | 11 to 14 V |
| C3-2 - Body ground | Ignition switch ON (IG) | 11 to 14 V |
| C4-2 - Body ground | Ignition switch ON (IG) | 11 to 14 V |
| *a | Front view of wire harness connector (to Fuel Injector Assembly) |
|
| ||||
| OK | |
| 2.INSPECT FUEL INJECTOR ASSEMBLY |
Check the fuel injector assembly (Click here).
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (FUEL INJECTOR ASSEMBLY - ECM) |
Disconnect the fuel injector assembly connectors.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| C1-1 - C10-20 (#10) | Always | Below 1 Ω |
| C2-1 - C10-17 (#20) | Always | Below 1 Ω |
| C3-1 - C10-18 (#30) | Always | Below 1 Ω |
| C4-1 - C10-19 (#40) | Always | Below 1 Ω |
| C1-1 or C10-20 (#10) - Body ground | Always | 10 kΩ or higher |
| C2-1 or C10-17 (#20) - Body ground | Always | 10 kΩ or higher |
| C3-1 or C10-18 (#30) - Body ground | Always | 10 kΩ or higher |
| C4-1 or C10-19 (#40) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||
| 4.CHECK HARNESS AND CONNECTOR (NO. 1 INTEGRATION RELAY - FUEL INJECTOR ASSEMBLY) |
Remove the No. 1 integration relay from the No. 2 engine room relay block and No. 2 junction block assembly.
Disconnect the fuel injector assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 2D-4 - C1-2 | Always | Below 1 Ω |
| 2D-4 - C2-2 | Always | Below 1 Ω |
| 2D-4 - C3-2 | Always | Below 1 Ω |
| 2D-4 - C4-2 | Always | Below 1 Ω |
| 2D-4 or C1-2 - Body ground | Always | 10 kΩ or higher |
| 2D-4 or C2-2 - Body ground | Always | 10 kΩ or higher |
| 2D-4 or C3-2 - Body ground | Always | 10 kΩ or higher |
| 2D-4 or C4-2 - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||